Soundtube SM31-EZ - Manual (Page 2)

1. Unpack speaker.
5. Attach speaker to surface
using installer-supplied
fasteners.
6. Aim speaker by pointing it
up or down and/or rotating
it.
3b. If mounting speaker
offset from wiring point, run
wire out hole in wall and
behind base plate through 2
mm standoff gap between
base plate and wall.
Standoff gap accepts up to
18-gauge flat signal wire.
4. Choose a secure
mounting surface with
sufficient strength to reliably
hold the speaker.
3a. If mounting speaker
directly over wire, ensure
base plate covers hole in
wall.
7. Done!
2. Connect speaker wire
leads to terminal screws on
back of base plate. Polarity
is indicated
SM31-EZ Installation Instructions For:
SM31-EZ speaker
1.435.647.9555 | 800.647.TUBE | www.soundtube.com