SoundTraxx Tsunami Quick Start - Manual (Page 15)

Tsunami Quick Start Guide Page 12 Tsunami Quick Start Guide Page 12
Diagnostic Lamps
Tsunami has two red LEDs on the circuit board which may be helpful for
resolving potential difficulties.
Pilot Light
The pilot light indicates that the
decoder is receiving power. If this
light does not come on, it may
indicate an improperly wired decoder.
It could also indicate a loose wire,
poor track pickups, no output from
the command station or other
problem with your layout wiring.
Fault Light
During normal operation, the
fault light will turn on and off with
the headlight, and is useful for
establishing basic control of the
decoder. Additionally, Tsunami
monitors a number of its input signals
and if a fault is found, reports an
error code by flashing the fault light
as well as the headlight and backup
light (if connected). The number of
times the light flashes corresponds
to the number of the error code. Error
codes whose conditions can usually be solved by the user are as follows:
Error 9: Over-temperature Fault
Error 10: Over-voltage Fault
Error 11: Motor Connection Fault
Error 12: Motor Over-current Fault
Error 16: CV Reset has ocurred and CVs have
been set to default values
Programming