Adjustments, Storage – Smithco AFC Sport Truck (sn AFT1032 – AFT1036) Operator Manual User Manual
Page 16

14
Service
ADJUSTMENTS
REAR ATTACHMENT LIFT
The rear attachment lift has several adjustmnets. By moving te 1/2" clevis pin to different holes you can achieve
several different lowering height.
A. Pin StorageOnly - Do not use forholding
up lift mechanism. Damage will occur.
B. Dump Box - Proper lift Storage when
dump box is used.
C. Attachment - Place 1/2" clevis pin in
one hole to control attachment lowering
limit. All three produce different lowering
heihgts.
D. Links can be reveresed front ot back to
furhter tailor lowering limit height.
STORAGE
If the engine will be out of service for two or more months, use the following storage procedure.
1. Clean the exterior surfaces of the engine.
2. Change the oil and filter while the engine is still warm from operation.
3. The fuel system must be completely emptied, or the gasoline must be treated with a stabilizer to prevent
deterioration.
If you choose to use a stabilizer, follow manufacturers recommendations, and add the correct amount for
the capacity of fuel system. Fill fuel tank with clean, fresh gasoline. Run engine for 2-3 minutes to get
stabilized fuel into carburetor. Close fuel shut-off valve when unit is being stored or transported.
To empty the system, drain fuel tank and carburetor, or run engine until tank and system are empty.
4. Remove the spark plugs. Add one tablespoon of engine oil into each spark plug hole. Install plugs, but do
not connect the plug leads. Crank the engine two or three revolutions.
5. Store machine in a clean, dry place.