Smithco TCV 2200 Turf Truck (sn DT2200 – DT2212) Operator Manual - Manual (Page 7)

5
Introduction
A. Oil Light - The oil light should come on when the ignition is on without the
engine running and go out when the engine is running. The oil light will
light when the oil pressure is low. If oil light should come on, shut engine
off immediately and find the cause.
B. Ignition Switch - The ignition switch has three positions: Off - Run - Start.
C. Tilt Steering - Hold lever down and adjust steering wheel to desired
position and release lever.
D. Lights - This rocker switch turns lights on by pushing on the top and off
by pushing on the bottom.
E. Hand Throttle - The hand throttle is used to regulate engine speed.
F. Cup Holder - Holds 2 large cups.
G. Park Brake - The park brake is only a parking brake. Pull back to release,
push forward to apply.
H. Dump Box Lever - The dump box lift lever is used to raise and lower the
dump box. Pull back to raise the dump box. Push forward to lower the
dump box.
I. Choke - The choke is used in starting the engine. Pull choke out to close
choke plate when starting a cold engine. Push in when engine starts. A
warm engine may not require "choking" to start.
J. Brake Pedal - Operates the hydraulic brakes on the front axle.
K. Forward Pedal - This pedal controls ground speed. Varying the amount of
movement of the pedal will vary the ground speed.
L. Reverse Pedal - This pedal controls reverse ground speed.
M. Hour Meter - The hour meter indicates hours of machine operation. It operates only when the ignition
switch is on. Located on left ROP's mount.
CONTROLS & INSTRUMENTS