Smithco TCV 2200 Turf Truck (sn DT2200 – DT2212) Operator Manual - Manual (Page 6)

4
Introduction
SET UP
The Dump Truck arrives from Smithco setup and ready for service. Depending on freight conditions battery may
need to be installed.
1. Check the tire pressure. The front tires are 18 psi (1.2 bar) and rear tires are 20 psi (1.4 bar).
2. Battery is located at the rear of the machine behind the engine. This
is a negative grounding system.
Connecting battery cables to the wrong post could result in
personal injury and/or damage to the electrical system.
Make sure battery and cables do not interfere or rub on
any moving part. Connect red positive (+) cable (A) to
battery first. When disconnecting remove black negative (-)
cable (B) first.
3. Check hydraulic fluid level in oil tank located on the right side of the
machine. Remove cap and add SAE 10W-40 API Service SJ or
higher motor oil if necessary. Fluid level should be about 2-2
1 /
2
" (5-6.4
cm) from the top of the tank when cold. DO NOT OVERFILL.
4. Fill fuel tank, located on left side, with Unleaded 87 Octane gasoline (mini-
mum). Your fuel tank is CARB compliant. Please check vent alignment in fill
cup.
Fuel is flammable, caution must be used when storing or handling
it. Do not fill fuel tank while engine is running or an enclosed area,
fumes are explosive and dangerous to inhale. DO NOT SMOKE
while filling the fuel tank. DO NOT OVERFILL
5. Machine should be greased before starting, refer to Maintenance for grease fitting location.
6. Read operating instructions before starting.
TOWING
When it is necessary to move the dump truck without the engine running, there are 2 things that need to be
done. First, the bypass valve built into hydrostatic pump must be "open" by turning it
1 /
4
turn to open. The valve
is located on the back side of the pump. An "open" valve allows fluid to pass through the wheels freely. When
normal driven operation is desired, valve should be "closed" by turning it clockwise. Failure to "close" the valve
with engine running means no power to wheels. Secondly, the hand brake needs to be manually released. The
hand brake is located between the seats. Push back to release.