Autoboom, Enabling autoboom while staring a job – Smithco Envizio Pro Quick Reference Guide User Manual
Page 15
1 4
AutoBoom
The following sections offer an overview of setting up and using an optional Glide
Series AutoBoom system with the Envizio Pro or Envizio Pro II. Refer to the
AutoBoom Calibration and Operation manual for detailed setup and calibration
information regarding the AutoBoom system.
To view the Glide Series AutoBoom settings and to enable automatic boom height
control, touch
, then
and
to access the Glide Series AutoBoom
setup screens.
Enabling AutoBoom While Staring a Job
1. Touch the
icon on the Home screen and configure any necessary options
on the Start Job - Verify Settings screen.
2. Complete the procedure in the
Start a Job
section earlier in this guide and
select the
to accept the displayed settings.
3. Before guidance will begin, the operator will be prompted to review the Glide
Series AutoBoom system settings.
The AutoBoom Setup screen will display similar to the following:
4. If
is displayed in the upper right corner, touch the icon to toggle the
AutoBoom system on.
5. Touch the Left or Right Boom Disabled button to toggle automated boom
height control for each boom.
Warning:
Booms may raise and lower unexpectedly. Make sure the area
around the booms is clear of obstructions and people before touching these
buttons.
6. Touch
if system adjustments are necessary, or to fine tune the AutoBoom
system.
7. Touch the
icon to open the job and begin guidance.