Smithco V-Star 94-201 (Sn V192) Operator Manual User Manual
Page 8
16. Stop engine before making repairs/adjustments or to check or add oil to the crankcase.
17. Use parts and materials supplied by SMITHCO only. Do not modify any function or
part.
These machines are intended for professional maintenance by trained operators on fine
turfgrass surfaces. Other use will void the warranty. Use by untrained operators may result in
personal injury, death, damage to the machine and damage to the environment.
For complete set-up instructions see V-STAR SERVICE MANUAL.
CAUTION !
The V STAR is shipped to you in transport position, which will allow the blades to go into the turf only ½”.
Before operating the V Star, remove all spacers from the bottom of caster shaft and place them on top of
the bearing tube.
Move spacers from here
to here
Once spacers have been removed from the bottom of the caster shaft to the top of the bearing tube it is
necessary to adjust the single point adjustment located on the left side of the unit to the desired depth.
(Note: You must loosen the locknut, which is located on the adjustment bolt. Once this has been
loosened you may proceed to turn the adjustment bolt clockwise to decrease the depth of cut or turn
counterclockwise to increase the depth of cut. Once depth has been determined reset locknut.
8