Smithco Sand Star Zee (ZTR) 45-500-A Parts & Service Manual - Manual (Page 9)

7
Service
PARTS MANUALS AVAILABLE ONLINE AT smithco.com
MAINTENANCE
WARNING! Before servicing or making adjustments to machine, stop engine and remove key
from ignition.
Use all procedures and parts prescribed by the manufacturer's. Read the engine manual.
LUBRICATION
Machine should be greased before starting. Use
general purpose No. 2 lithium base grease. Lubri-
cate every 100 hours.
A. Rear attachment lift yoke.
B. Right attachment lift mount.
C. Left attachment lift mount.
D. Center attachment lift yoke.
E. Center lift lever.
F. Front fork.
TIRE PRESSURE
Caution must be used when inflating a low tire to recommended pressure. Over inflating can cause tires to
explode. Rear tires should be 5 psi (0.34 bar). The front castor wheel should be 20psi (1.38 bar). Improper infla-
tion will reduce tire life considerably.
ENGINE
Change and add oil according to chart below. Do not overfill. Engine oil capacity is 2 quarts. We recommend
high-quality detergent oils classified for service SF, SG, SH, SJ or higher. Do not use special additives. Outdoor
temperatures determine the proper oil viscosity for the engine. Use the chart to select the best viscosity for the
outdoor temperature range expected.
SAE VISCOSITY GRADES
Use of multi-viscosity oils (10W-30, etc.) above 40° F (4° C) will result in high oil consumption and possible
engine damage. Check oil level more frequently if using these types of oils.
SAE 30 oil, if used below 40° F (4° C), will result in hard starting and possible engine bore damage due to inad-
equate lubrication.