Smithco Sand Star Zee (ZTR) 45-500-A Parts & Service Manual - Manual (Page 8)

6
Introduction
PARTS MANUALS AVAILABLE ONLINE AT smithco.com
OPERATION
STEERING CONTROL LEVERS
Acquaint yourself with the steering before operating the machine. This machine is equipped with two steering
control levers (A) that make the machines speed and direction continuously variable. The steering controls can
be moved forward or backward about a neutral position. The neutral position is locked when the steering control
levers are moved outward and the machine will stand still.
Move in a straight line - By moving both controls an equal amount forward or backward, the machine will move
in a straight line forward or backward respectively.
To turn right while going forward - Move right control lever towards the neutral position. This will cause the
rotation of the right wheel to reduce which will result in the machine turning to the right.
To turn left while going forward - Move left control lever towards the neutral position. This will cause the rota-
tion of the left wheel to reduce which will result in the machine turning to the left.
Zero Turn - Zero turn can be achieved by moving one control lever backward, behind neutral position, and care-
fully moving the other control lever forward from its neutral position. The rotation direction is determined by
the control lever that is moved backward behind the neutral position. If left control lever is backward,
machine will turn left. If right control lever is moved backward, machine will turn right.
WARNING! The machine can move rapidly if one steering control is moved much further than the
other.
Reverse Neutral Forward Right Zero Turn
WARNING! Do not drive up and down hills with slopes greater than 10°. Do not drive across slopes.
STARTING ENGINE
Before operating this machine, become familiar with all controls and functions of
these units. Also complete all maintenance requirements and read all safety warn-
ings. By knowing the machine thoroughly, how it operates and by doing the pre-
scribed maintenance steps, you can expect relatively trouble-free operation for years
to come.
1. Set park brake. Start safety switch is on the park brake.
2. The ignition switch is a three position on gas and four position on diesel. Insert
key (A) and turn clockwise until engine starts (C). Release key and it will return
to run position (B). Use choke and hand throttle as necessary.
3. Allow engine to idle and warm up a few minutes before selecting a direction of
travel.
4. To shut off engine on all gas machines turn key to the stop position.