Smithco Diesel Super Rake 17-001 Accessories Manual - Manual (Page 41)

B-19
Center Attachment
42-210 GRADER BLADE PARTS LIST
REF# PART# DESCRIPTION QTY
1 HHP-18 Bridge Pin 1 /
8
2
2 42-207 Grader Blade 1
3 HBFL-516-18-075 Flange Bolt, 5 /
16
- 18 x 3 /
4
4
HNFL-516-18 Flange Whiz-Loc Nut, 5 /
16
- 18 (not illustrated) 4
4 42-386 Grader Blade Mount 1
42-210 GRADER BLADE INSTALLATION INSTRUCTIONS
1. Install Grader Blade (Ref 2) onto Attachment Lift by sliding tabs onto clevis pins and secure with Bridge
Pins (Ref 1).
2. Install Grader Blade Mount (Ref 4) on seat panel.
3. Position the Grader Blade Mount (Ref 4) to be centered on the rear of the Seat Panel as illustrated. Mark
the hole locations on the Seat Panel. Using an Ø 11 /
32
drill located the holes at the four marks made
previously. The top two holes will be drilled through the fiberglass and the steel panel and the rear holes
will be drilled through the fiberglass only.
4. Bolt the Grader Blade Mount (Ref 4) to the Seat Panel using the four 5 /
16
-18 Flange Bolts and Flange
Nuts (Ref 3).
5. The Grader Blade Mount is used for the storage of the Grader Blade when not in use. To store, turn the
Grader Blade to the position illustrated in the Grader Blade Mount Drawing and place in the Grader
Blade Mount.
6. Turn machine on and test for proper operation.