Smart Avi HDR 8X8 - Manual (Page 7)

7 www.smartavi.com
To assign an output to an input, press SWITCH. A blinking block cursor
will appear. Use UP and DOWN to select the input that you would like to
assign. Once the cursor is over the desired input port, press ENTER to enter
editing mode. Press UP and DOWN to select the output port. Once you
have selected an output, press ENTER to save the configuration. To escape
from editing mode, press ESC.
IMPORTANT: Because HDCP takes time to negotiate, when switching ports,
wait 2 seconds for the process to complete. Failure to do so may cause an
error with the HDCP and the HDR8X8/HDR16X16 may lock up.
Default Display HDR16X16
Front Panel Buttons
Using the Front Panel Control
During normal operation, you will see a list of ports on the front panel
display.
NOTE: To lock the front panel buttons to avoid any accidental
changes, press ESC + MENU + ENTER + SWITCH at the same
time. The display will indicate that it is locked. Repeat the
procedure to unlock the front panel.