Smart Avi HDR 8X8 - Manual (Page 29)

29 www.smartavi.com
COMPUTER IP ROUTER SMTCP-2
RS-232
SERIAL
CAT5
CAT5
MATRIX SWITCH (NOT CONNECTED)
Connecting to the SMTCP-2 for the first time WITHOUT DHCP
The first time you connect the SMTCP-2, you will need to perform the following steps to
set the initial configuration. This includes establishing an HTTP connection and manually
setting the IP address for the SMTCP-2.
1. Power off all devices.
2. Use a female to male Straight-Through RS-232 (Serial) cable
to connect the SMTCP-2 to the computer.
3. Use a CAT5 ethernet cable to connect the SMTCP-2 to a TCP/
IP network via a network router or other network connection.
4. Power on the computer and run a terminal program such as Hyperterminal to open
a serial connection to the SMTCP-2 using the standard 9600 baud, 8, N, 1, None Flow
Control configuration.
5. While powering on the SMTCP-2, press and hold Shift-1 (exclamation) until a
command prompt appears.
6. Press enter to show the network configuration help screen as follows:
Command:
ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ»
º Network Configuration help º
ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ
Enter a command followed by optional parameters
Commands are SET DHCP INFO RESET and QUIT/SAVE
SET command allows you to change the network configuration:
SI xxx.xxx.xxx.xxx = Set IP Address
(if IP address is not entered then DHCP is ENABLED)
SM xxx.xxx.xxx.xxx = Set IP Mask
SG xxx.xxx.xxx.xxx = Set Gateway Address
RN = Reset Network Params:
IPADDR = 192.168.0.2
IPMASK = 255.255.255.0
GATEWAY = 192.168.0.1
DHCP ON = Enable DHCP
DHCP OFF = Disable DHCP
INFO = Display network configuration
RESET = Factory reset
QUIT = Saves configuration and quits
SAVE = Same as QUITNOTE: the above IP address is for demonstration purposes
only. Actual results may be different.
7. Follow the instuctions to manually assign an IP address to the SMTCP-2.
8. See page 19 for instructions on how to connect to the SMTCP-2 via HTTP.
Using the SMTCP module (continued)