beautypg.com

Smart Avi HDR-Ultra User Manual

Page 7

background image

7

Debug mode is a more user-friendly way of operating the HDR-ULTRA and it
also includes instructional menus. To enter the Debug Mode, type in “d on”
followed by .

Below are the Debug Mode Menu Items:

===========================================================================
Command Line Interface Help:
d

Enable/Disable debug

d [on][off]

sw

Switch Port

sw [output] 1-16 [input] 1-16

br

Broadcast Port

br [input | / | \] 1-16

om

Set output mode

om [output] [mode# (0-2) | ?]

o

Enable/Disable Output

o [output] [0 = disable | 1 = enable]

to

Toggle Output Enables

to

q

Query Crosspoints

h

Toggle Hotplug

h [input]

olev

Set Output level

olev [output | ? | r | a] [level (1-10)]

edid

Manage EDID

reset Restore Factory Settings
boot

Reboot matrix

info

Display matrix info

help

Command list

?

===========================================================================


Learning the EDID of the Monitor Using Debug Mode

1. Connect CAT5e/6 cable from one of the HDX-Ultra Receivers to the

OUT1 of the HDR-ULTRA.

2. Connect a straight-through male-to-female RS-232 cable from the com-

puter to the RS-232 port of the HDR-ULTRA.

3. Run HyperTerminal on your PC (or use the terminal client of your

choice).

4.

Cycle the power of the HDMI (reset) and you should see the following
on the screen:

SmartAVI HDMI 16X16 ver 12.06.11#1

5. To enter the Debug Mode type “d on” and hit ENTER. You will see the

following prompt:

DBG>

6. Type in “edid” and hit ENTER to go to Manage EDID:

EDID>

7.

Type in “learn” and hit ENTER to learn the monitor plugged in port 1:

EDID> learn

Successfully learned EDID!

Note: EDID learning is also available using front-panel selection.