Smart Avi QuadKVM - Manual (Page 8)

8 www.smartavi.com
Screenshot of the QuadKVM’s Main OSD.
SMARTAVI
QUADKVM
F2 . MODE
F3 . CONFIGURATION
F4 . VIDEO
F5 . HELP
F1 . SYSTEM
The QuadKVM has an OSD that is accessible
by pressing MENU on the front panel.
To select an option:
On-Screen-Display (OSD) Operation
The SYSTEM OSD option (F1 from the main OSD)
allows the user to configure the hotkeys (F1),
change the OSD position (F2), select from set
users (F3), and scan the inputs 1-4 once (F4).
SYSTEM
F2 . OSD POSITION
F3 . USER SELECT
F4 . SCAN
F1 . HOTKEY CFG
• press 1/2/3/4 on the front panel (1-4 only)
• use the keyboard up and down arrow
keys, pressing enter to select, left arrow to
go back.
• press the corresponding F-key
To exit the OSD, press MENU or escape.
The MODE OSD option (F2 from the main OSD)
allows the user to set the mode. The available
modes via OSD are PiP (Picture in Picture) (F1),
Full (F2), and Quad (F3).
MODE
F2 . FULL
F3 . QUAD
F1 . PIP
The CONFIGURATION OSD option (F3 from
the main OSD) allows the user to back up the
settings (including pre-defined user settings)
(F1) and to perform a factory reset to reset the
QuadKVM to its factory default settings (F2).
CONFIGURATION
F2 . FACTORY RESET
F1 . SAVE SETTINGS
The VIDEO CONFIG OSD option allows the user
to view the video status (F1), select the output
resolution (F2), and set the horizontal (F3) and
vertical (F4) positon of the video output.
VIDEO CONFIG
F2 . RES SELECT
F3 . HORZ POSITION
F4 . VERT POSITION
F1 . VIDEO INFO
<- to go back
<- to go back <- to go back
<- to go back