Sim2 MICO 50 - Manual (Page 69)

English
MiCO 50
31
Troubleshooting
Problem Check
Projector does not start
Projector power cord is not plugged into the wall outlet.
Projector power switch does not turn on.
Remote control batteries have run out.
No picture
The selected input mode is wrong.
Cables may be incorrectly connected to the rear panel of the projector.
Power to the external connected device is off.
The video signal format of the video equipment is not set correctly.
faded
Picture adjustments are incorrectly set.
blurred
Adjust the focus
The projection distance exceeds the focus range.
Noise
(Component/VGA input only)
Perform "Frequency" adjustments also in component.
Perform "Phase" adjustments also in component.
green on COMPONENT
Change the input signal type of the video equipment.
dark / bright and whitish
Picture adjustments are incorrectly set.
too bright and whitish
Picture adjustments are incorrectly set.