Sea Eagle RazorLite Kayaks (393RL RazorLite, 473RL RazorLite) - Manual (Page 8)

Locate a relatively
clean space to unpack
the boat and lay it out
flat.
Inflate the sides and
floor (in no particular
order). The working
pressure for all cham-
bers is 10 PSI.
Skeg
The removable skeg
helps control yaw and
improves paddling
speed.
Turn the boat over and
slide the skeg into the
base. It only slides in
facing one way. Slide
the locking tab into its
groove until it clicks into
place. If the skeg does
not slide in, do not
force it. Refer to an
easy fix on page 10.
Kayak Paddle
The asymmetrical
spoon blade design of
this kayak paddle will
allow for a smooth
entry and an even pull,
maximizing the power
of each stroke. It also
requires less gripping
force.
Each paddle comes
with two drip guards, a
right and left blade and
two shaft pieces that
connect using snap
lock buttons.
NOTE: Assembly for
the two-part paddle is
similar.
Begin by connecting
the two halves of the
shaft together by insert-
ing the push pin on the
end of one shaft into
the end of the other
shaft that has the feath-
ering holes.
Next, slide the drip
guard up the shaft to
about an inch above
the button hole. Insert
the blade into the shaft
and adjust until the but-
ton locks the blade in
place. Repeat for the
other side.
7
RazorLite Kayaks | ASSEMBLY & INFLATION ASSEMBLY & INFLATION