Sea Eagle NeedleNose SUP (NN116, NN126, NN14) - Manual (Page 7)

Take adapter number 1
from the cluster and
firmly push it into the
grey tube in the end of
the hose. To ensure that
the adapter is fully
seated on the tube,
push it until the end of
the tube pushes past
the raised ring in the
adapter.
Connect the other end
of the hose to the red
inflation port at the top
of the pump, located
near the ON and OFF
buttons.
Adjust the pressure dial
to the operating pres-
sure of your Sea Eagle.
PSI is marked in red on
the dial. Never turn the
dial when the device is
under pressure as this
will immediately cause
the instrument to break.
Connect the quick con-
nector at the end of the
power cord into the
quick connector at-
tached to the pump.
To connect the pump to
a 12V battery, use the
cord with alligator clips
at the end of the exten-
sion cord. Connect the
red clip to the positive
pole and the black clip
to the negative pole.
CAUTION: Cross con-
necting wires could
damage the pump and
boat.
If you ordered the
portable battery, con-
nect the battery to the
quick connector onto
the pump.
To charge the portable
battery, plug it into the
charger and then plug
the charger into a
household electrical
outlet. The light on the
battery charger will blink
red until fully charged.
When it is fully charged
the light will be a solid
green.
Keep the pump in its
carry bag to make
transportation easier
and to protect the pump
from sand which could
jam it. The carry bag
has compartments for
the pump, battery hose.
6
INFLATION: VALVES & PUMPS (continued)