Scotsman RFE33 - Manual (Page 4)

Customizing Door Panel:
A custom door panel may be installed in front of
the standard one. Any panel 14
3 ⁄
4
" wide, 28 15 ⁄
16
"
high and 1 ⁄
4
" thick or less at the edges may be
used as a decorator panel. Examples of decorator
panels include wood to match the adjacent
cabinets; metal of different colors to match nearby
appliances; or just about any material that will fit.
Scotsman has a stainless steel panel available to
fit this machine, the kit number is SS33. If the
material is less than 1/4" thick, the space between
the new panel and the original may be filled with
cardboard.
1. Remove single screw and the left hand hinge
filler plate from the top of the door.
2. Remove two screws from the top of the door
and lift off the door handle.
3. Open the door slightly, about one-third
or so; then, remove the front screw holding
the hinge to the door.
4. Loosen the rear screw of the hinge just
enough to allow the door to sag or move
forward. This will allow access to the top of
the channels at the right and left edges of
the door.
5. From the top of the door, insert the
decorator panel (pre-cut) evenly into the
channels; carefully slide the panel all the
way down until the panel is fully into the
bottom channel.
6. Check that the panel is the in all the way
and does not protrude past the top edge of
the door.
7. Push the top hinge corner of the door IN
to align screw hole in the hinge with the
screw hole in the door. Install the screw
previously removed. Tighten the other
screw.
8. Replace the door handle and filler plate;
secure with screws previously removed.
Hinge filler
plate
Custom Panel,
Thin Panel
Shown With
Filler.
Parts Involved in Customizing Door Panel
Hinge
Door with
groove
Door Handle
RFE33
November 1995
Page 4