Changing the fuse, Recycling used products – Dynaudio SUB 600 User Manual
Page 36
Owners Manual
33
Care and Maintenance
Changing the fuse
The fuse is placed on the rear of the subwoofer below the mains power input. It can be
changed without removing the amplifier module.
To change the fuse:
1. Switch off the mains power switch and unplug the power cable.
2. Pull out the fuse holder
3. Replace fuse with same type and rating
4. Push fuse holder back firmly until it is locked in its position.
Recycling used products
This product is subjected to the European Union Waste Electrical and Electronic
Equipment directive (WEEE), 2002/96/EC.
This product must not be disposed of as unsorted municipal waste but must be collected
separately and disposed according to your national regulations.
WARNING
Risk of Fire
For continued protection against risk of fire, replace only with same type fuse and
rating.
100-120V/220-240V
~ 50/60Hz 3.15A
FUSE T3.15A L 250V
OFF
ON