Royal Vacuums CH50102 - Manual (Page 9)

9
2.4 To move your cleaner
from room to room, put
handle in upright
position, tilt cleaner back
on rear wheels and push
forward.
transportinG Cleaner
2.5 The cleaner can
also be moved by
using the carry handle
(A).
CarrY handle
2.6 The handle of your
cleaner has three
positions; (A) upright for
storage and when using
cleaning tools; (B)
operating position for
general operation on
carpet and floors; (C)
low for reaching under
low furniture. Step on
handle release lever to
lower handle into each
position (B & C).
handle positions
2.3 Plug cord into electri-
cal outlet. LED lights will
flash on and then off.
To turn cleaner ON, push
ON/OFF switch to “
|
“
position.
To turn cleaner OFF, push
ON/OFF switch to “
O
”
position.
on-oFF switCh
2.3 2.4
A
2.5 2.6
A
B
C
Carpet heiGht adjustMent
2.7 The cleaning of
carpet and rugs takes
place at the nozzle.
When it is necessary to
raise and lower the
nozzle for various carpet
pile heights, turn the
nozzle control knob (A)
to the desired setting.
2.9
2.8 For ease in turning knob, the handle
should be in the upright position (A).
The nozzle will not move into the adjusted
position until the cleaner handle is lowered
to the operating position (B).
• Lowest setting (1):
for bare floors and low pile, level loop, kitchen-type or commercial grade carpet.
• Medium setting (2): For medium pile types of carpet.
• Higher settings (3-4): For very deep pile carpet where easier pushing effort is desired, while maintaining good
cleaning performance.
Note:
If the cleaner is difficult to push, turn the control knob to the next higher setting.
2.9 For maximum cleaning performance, the following carpet height settings are recommended:
For Models with Manual heiGht adjustMent
CAUTION
! !
Not to be used for grooming a pet!
2.7
A
2.8
A
B