Royal Vacuums UR30090 - Manual (Page 19)

10
FILTERS:
How to Clean
Secondary Filter
4.5 The secondary filter (A) protects the motor from
dirt particles.
If filter becomes dirty, pull off grill and lift out filter.
Hand wash filter in cold water. Let filter air dry for 24
hours. Reposition dry filter and grill.
What to Buy:
Secondary Filter
Use only genuine
ROYAL ® Secondary
Filter with your
vacuum. When
purchasing a new
Secondary Filter, ask
for ROYAL ® Part No.
902417001.
Final Filter
The final filter assists in the filtration process to
return clean air to the room.
4.6 To remove the filter, pull tab on filter holder down
and remove filter.
Lift out filter (B) and hand wash it in cold water.
Let filter air dry for 24 hours and reposition it on the
side of the filter holder and push filter holder back
into cleaner.
What to Buy:
Final Filter
Use only genuine
ROYAL ® Final Filter
with your vacuum.
When purchasing a
new Final Filter, ask
for ROYAL ® Part No.
902418001.
4.6
B
IMPORTANT
Allow filter to dry completely before replacing.
Dry filter on edge so air circulates on both sides
of filter. This may take up to 24 hours.
4.5
A
Actual model may vary from images shown.
4.7 4.8
4.9
To reduce the risk of personal injury - Unplug
before servicing or cleaning vacuum.
Do not operate cleaner without either the
secondary or final filter in place.
WARNING
! !
BRUSHROLL
: How to Clean
4.7 Turn vacuum over so bottom side is facing up
and remove the (6) screws (A).
4.8 Pivot out bottom plate away from hidden latch
(B) and remove any debris and/or hair from the
brushroll.
4.9 Reposition bottom plate, aligning latch (B) and
fastening all (6) screws (A). Press firmly at latch (B)
area to ensure that it is properly latched.
A
CAUTION
! !
To reduce the risk of injury from moving parts -
Unplug before servicing.
A
B
B