Royal Vacuums UR30090 - Manual (Page 18)

9
FILTER BAG:
How to Replace
4.1 To change filter bag, push up door release latch
with thumb and pull handle forward. Remove door.
4.2 Push on the red lever over a trash receptacle
and drop the bag into the trash.
4.2
4.3
IMPORTANT
Do not clean out old filter bag and reuse.
Discard used filter bag.
4.1
4.4
C
Check filter bag from time to time. It is recommended
that you change the filter bag when dirt reaches the
dotted line. If more dirt than this accumulates, your
cleaner will not operate effectively.
FILTER BAG:
When to Replace CAUTION
! !
Very fine materials, such as face powder or
cornstarch, may seal the filter bag and may
cause it to burst even though it is partially full of
dirt. When the cleaner is used to remove
material of this nature, change filter bag often.
What to Buy: Filter bag
Use only genuine ROYAL ® bags with your
vacuum. When purchasing a new bag, ask for
ROYAL ® HEPA Type Y Bag Part #1RY3650000
or ROYAL-AIRE Type Y Bag Part #43655127.
IMPORTANT
All new carpet has loose fibers which can fill the
bag quickly while vacuuming. This type of debris
does not activate the “Check bag” indicator
available on some models.
Actual model may vary from images shown.
4. MAINTENANCE
Familiarize yourself with these home maintenance tasks as proper use and care of your vacuum will ensure
continued cleaning effectiveness.
Any other servicing should be done by an authorized service representative.
4.3 Hold new filter bag as shown. Slide the
cardboard sleeve into the bag holder until the bag
is securely in place.
4.4 Reposition bag door by placing tabs on bottom
of door into opening (C). Make sure the filter bag is
securely tucked into the vacuum.
Push door handle to snap securely shut.
To reduce the risk of personal injury - Unplug
before servicing or cleaning vacuum.
Do not use vacuum without filter bag in place.
WARNING
! !
A Thermal Protector has been designed into your cleaner to protect it from overheating. When the
thermal protector activates the cleaner will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Check fullness of bag, change if needed.
3. Inspect the nozzle inlet, hose connector, hose, bag opening inlet, secondary filter and final
filter. Clear any obstructions if present.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will
deactivate and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner needs
servicing.
NOTICE
! !
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water,
take it to a service center prior to continuing use.