Royal Cozyfires Super Hotbox Toaster MK4 - LPG - Manual (Page 12)

12 HM83 010710
2.4.4.3 INSTALLING THE APPLIANCE (Fitting the firebox in the opening) Super Hot Toaster Mk4
Prior to fitting the firebox, fit the foam seal provided. It should be positioned approximately 10mm from the outside edge of the metalwork.
This ensures maximum flow of air through the flue.
There are two options to fit the firebox into the opening:-
Fix four `screw eyes’ to the rear of the opening. (Note the minimum and maximum height restrictions in the diagram above). Thread the
wire cable downwards through the two holes located on the lip of the flue outlet. Thread through the top two `screw eyes’ and then through
the bottom two `screw eyes’. Finally thread through the two holes at the rear of the firebox.
Pull the wire cable and carefully push the firebox into a central position in the opening. Thread each end of the wire cable through the
adjusting screw and then through the retain bush. Adjust and tighten to ensure that a good seal is made between the firebox and back
panel.
Fig. 17
OPTION 1 WALL FIXING
Position the firebox in the centre of the opening. Mark
the holes provided in the firebox and drill, plug and
screw to either the base or trim support of the fire.
Replace the burner unit (Fig 17).
OPTION 2 WIRE CABLE FIXING
This method is for when it is undesirable to deface or
risk damage to the back panel (Fig 18).
Four `screw eyes’ are fixed to the rear of
the opening with wall plugs.
Min height from base of opening–150mm
Max height from base of opening–
300mm
`Screw eyes’ to be 160mm apart
Min Height
150mm
Max Height
300mm
160mm apart
Fixing hole
Fixing hole
Fixing hole
Fixing hole
Two fixing holes in base of firebox
Fig. 18
Cable fixing holes
Adjusting screw
Screw eye
Flue outlet
retaining bush