Royal Cozyfires Super Hotbox Toaster MK4 - LPG - Manual (Page 11)

11 HM83 010710
2.4.4 INSTALLING THE APPLIANCE (Fitting the appliance in position) Super Hot Toaster Mk4
BEFORE COMMENCING WORK, TURN OFF ALL APPLIANCES THAT ARE FED BY THE METER.
ISOLATE THE GAS SUPPLY BY TURNING OFF AT THE METER.
It will be necessary to dismantle the burner unit from the firebox before installation into the opening. Remove the two fixing screws on the
left and right hand side of the burner. Lift and pull forward (Fig 15).
2.4.4.1 INSTALLING THE APPLIANCE (Connecting the gas supply)
A restrictor elbow complete with pressure test point is fitted to the appliance to facilitate servicing. The gas supply to the appliance may be
from the front left hand side or as a concealed fitting from the rear left or right hand side. The preferred method of connection should be
from the rear left.
It is important to note the requirements of the current issue of BS 6891, dealing with enclosed pipes. This standard requires that when a
gas pipe is fed through a wall, it should be enclosed in a gas tight sleeve to protect against failure caused by movement and shall be
constructed to prevent passage of gas either between the pipe and sleeve or sleeve and wall.
2.4.4.2 INSTALLING THE APPLIANCE (Restrictor plate)
A restrictor plate is supplied with the IFU kit. This restrictor is for use when installing the appliance into a CLASS 1 FLUE ONLY! The
restrictor plate MUST NOT BE USED ON CLASS 2 FLUES. The restrictor plate is fixed to the flue outlet using the two screws provided in
the IFU kit (Fig 16).
Fig. 15
Fixing Screw Fixing Screw
Fig. 16