ROTEL RC1070 - Manual (Page 14)

14 RC-1070 Stereo Control Amplifier
No Sound
Be sure the RC-1070 is turned on. The VOL-
UME control indicator light and the selected
function indicator should be lit. Be sure the
LISTENING selector is set to the proper input.
Check to see if wthe MUTE function has been
engaged. Check the signal source to see if it
is functioning properly. Make sure the cables
from the signal source to the RC-1070 inputs
are connected properly. Check the power
amplifier for power and proper operation.
Check all the wiring between the RC-1070,
the power amplifier, and the speakers.
Specifications
Total Harmonic Distortion (20 Hz-20 kHz)
< 0.006%
Intermodulation Distortion
< 0.006% at 1V output (60 Hz:7 kHz, 4:1)
Input Sensitivity/Impedance
Line Level: 150 mV/24 kOhms
Phono (MM): 1.2mV/68k ohms
Output Level/Impedance
1V/100 Ohms
Usable Headphone Impedance
8 – 2,000 Ohms
Frequency Response
Line Level: 4Hz – 100kHz, +0, -3dB
Phono: 20Hz – 20kHz, ±0.5dB
Signal to Noise Ratio (IHF “A” weighted)
Line Level: 95 dB
Phono: 70 dB
Phono Overload:
70mV
Power Requirements
USA: 115 Volts, 60 Hz
CE: 230 Volt, 50 Hz
Power Consumption
10 Watts
Dimensions (W x H x D)
430 x 92 x 344 mm
17” x 3
5/8
” x 13
5/8
”
Weight (net)
5.4 kg, 11.9 lbs.
All specifications are accurate at the time of print-
ing.
Rotel reserves the right to make improvements
without notice.
Rotel and the Rotel HiFi logo are registered trade-
marks of The Rotel Co, Ltd., Tokyo, Japan.