Dimplex SAHARA FIREPLACE 6903950000 - Manual (Page 9)

6
5. Adjust the wall-mounting bracket so the bubble
on the level is centered between the two black
lines.
6. Mark 5 other mounting screw locations, on the
wall, ensuring that the wall bracket stays level.
7. Install the supplied wall anchors on the marked
locations by placing a #2 phillips screwdriver
into the recess of the anchor. Press the anchor
into the wall in the desired marked position
while turning the anchor clockwise until it is flush
with the wall
9. Insert the wall anchor screws through the wall
bracket and thread into the wall anchors.
Tighten the screw. (FIGURE 4)
10. Install the remaining screws through the bracket
and into the wall studs as required.
Note: At least two of the mounting screws
must be installed into a wall stud.
11. Remove glass assembly (Figure 5).
Figure 4
Wall Anchor
Screw
Wall Bracket