RF Neulink NL5000-T - Manual (Page 9)

9
3 NL5000-T INPUT/OUTPUT CONNECTOR
Connector Pinout
Pin Number Name Description Comments
1 CS0 Channel Select low bit
2 CS1 Channel Select mid bit
3 CS2 Channel Select high bit
4 MIC IN Microphone Input Input for microphone type
signals to be transmitted.
Signals at this input are
pre-emphasized, limited,
and filtered.
5 CSN High/Low Power or Channel 1/2
6 RAW SUPPLY Power Supply Input Positive Supply voltage
input.
7 AUX IN Auxiliary Input Wideband input for data.
8 AUX OUT Auxiliary Output Wideband output for data.
9 PGN IN/OUT Programming I/O External programmer
connects here.
10. CTS Clear to Send Active high when
transmitter can accept
modulation.
11.
RX MON Monitor Breaks squelch in receive.
12. AUDIO OUT Audio PA Output Output of audio PA.
13. DCD Carrier Detect Carrier detect output.
14. PTT/RTS Push to Talk Activates transmitter.
15. GND Ground Negative supply point and
reference for all inputs.
Pinout Description
Pin Number Description
1 CS0-Least significant bit of the channel select lines. Active high 5 volt
TTL/CMOS level. Internal 10 kΩ pull-up to +5 volts.
2 CS1-Mid bit of the channel select lines. Active high 5 volt TTL/CMOS level.
Internal 10 kΩ pull-up to +5 volts.