RF Neulink NL5000 Rev B0 - Manual (Page 18)

NL5000 User Manual Rev B0 17
6.6 CONFIGURATION SOFTWARE DROP-DOWN MENUS
The NL5000 Configuration Software has three drop-down menus, selectable via
tabs at the top of each page, which are always visible. These menus are:
6.6.1 File
Allows the management of Configuration Software files. There are four
sub-menus under this menu:
Open File Opens a previously saved Configuration Software file. This is used to
copy one radio modem’s Configuration Software to another. This is of benefit when
a number of radios are to set to the same frequencies and with the same switch
settings.
Save File Allows the current Configuration Software to be saved. This feature is
also presented upon exiting the Configuration Software.
Print Prints a summary of the current Configuration.
Change Password Allows the password for the Configuration Software to be
changed. Note that the password is specific to the Configuration software and not
to the radio modem. A password is required to access the alignment page or to
update firmware.
Quit Exits the program. Upon exiting the Configuration Software via the exit
button, the user will be presented with a box which allows the saving of the current
Configuration. This is useful if a number of other radios are to be programmed with
the same frequencies and settings. If one does not wish to save the current
Configuration, the exit button should be selected.
6.6.2 Radio
Read Reads the radio’s Configuration. This would normally take place when the
Configuration Software is opened, but if a radio is disconnected and another radio
is connected, this sub-menu function would force the program to update itself with
the new connected radio.
Summary Presents a summary of the radio’s entire configuration on
one screen.
Upgrade Firmware Brings up a screen which allows upgraded firmware to be
loaded into the radio.
6.6.3 Edit