beautypg.com

Operating the conveyor, Reverse operation – Rena TB-390 User Manual

Page 8

background image



TB-390 Operations Rev. 7/30/2014

7

Power

Switch

Speed

Control

OPERATING THE CONVEYOR

1. Connect power to the conveyor. See the

section titled “Power Connection”.

2. Turn on the conveyor and the printer or

tabber.

3. Feed a single piece of stock through the

printer or tabber and onto the conveyor.
Observe the way it is received by the
conveyor.

4. Loosen the locking knob [A] and adjust the

position of the stacking wheel assembly so that
the lead edge of the media just touches the
stacking wheels, as it exits the printer or tabber.

5. Adjust the speed control knob to set the desired

conveyor transport speed.

Clockwise = Faster (bigger gap between pieces or
less overlap).
Counter-clockwise = Slower (smaller gap between
pieces or more overlap).


Note: When the optional back-stop is used; the speed of the conveyor must be set so that
adjacent pieces are overlapping each other.
When the standard drop-tray is used the media does not need to be overlapped.

REVERSE OPERATION

The TB-390 can be configured to run from “right to left”
or from “left to right”.

If the conveyor is not running in the desired direction, it
can be reconfigured as follows:

1. Disconnect the power cord from the conveyor.

2. Slide the position of the “transport direction

switch”, located under the conveyor, to the
opposite position.

3. Reconnect the power cord to the conveyor.

4. If necessary; move the guide roller assembly and the stacking tray (back-stop or drop-

tray) to the opposite end of the conveyor.