Drop-tray installation – Rena TB-390 User Manual
Page 6

TB-390 Operations Rev. 7/30/2014
5
DROP-TRAY INSTALLATION
If you plan to install the optional dryer, please read the section titled “Dryer Mounting Kit
Instructions” before proceeding.
To assemble and install the Drop-Tray on the Conveyor follow these steps:
1. Disconnect the power cord from the unit.
2. If installed; remove the two screws holding the optional
back-stop to the conveyor and remove the back-stop.
See the “Optional Accessories” section, for more info on
the optional back-stop.
3. At the exit end of the conveyor; remove the four screws
[A] that mount the cover plate to the conveyor. Do not
remove the cover plate.
Note: The TB-390 can be configured to run from “right to left”
or from “left to right”. The exit end of the conveyor is
determined by the direction of the conveyor.
4. While holding the cover plate in place; install the Drop-
Tray Support Bracket [B], to the exit end of the conveyor,
using the four screws removed in Step 2.
5. Install the Paper Guide Roller assembly, to the exit end of
the conveyor, using the four screws supplied [C]. The
Paper Guide Roller assembly should be mounted as shown
with the rollers resting on the exit roller of the conveyor.