Rena EasyFeed Lite - Manual (Page 9)

OPERATING THE FF-309
6
Operating the Feeder
Adjusting the Feeder
The Feeder is properly aligned with the Tabber when it is installed. Check alignment when using
with other equipment. The Media Guide on the non-operator side of the Feeder is fixed in
position for proper alignment of the media.
Adjust the Feeder to feed media:
1. Open the Adjustable Media Guide to provide room
for the media.
2. Loosen the Separator Locking Knobs [1] and raise
the Sheet Separators [2]. Install one sheet of media
under the Separators and lower them into contact
with the media. Tighten the Locking Knobs.
NOTE: For media thicker than 1/2 folded sheets you
can add one sheet of the material to the media
before tightening the Locking Knobs. This gives
thicker media a little more room to feed.
3. Move the Adjustable Media Guide to within
1/32-inch of the media and tighten the
Locking Knob.
4. Adjust the Rear Media Support Guide so that
the media is approximately 1/2-inch above
the media support as shown.
NOTE: The above is a starting guideline. The
height of the media above the Support Guide
may vary to obtain optimum feeding.
5. The Forwarding Rollers on the Feeder are
adjustable for media thickness. This is
particularly helpful when feeding media over
1/8-inch thick. To adjust the Forwarding
Rollers, loosen the Media Thickness Locking
Knob [3], place a piece of media under the
Forwarding Rollers [4], and then tighten the
Knob.
NOTE: To increase or decrease the pressure
on the Forwarding Rollers adjust the lever [5]
while tightening the Locking Knob [3].