REMKO Smart Count Activation - Manual (Page 7)

2 Installing the
Smart Count
NOTICE!
Before removing and inserting the SD card, the
system must be powered down!
1. After the system has been powered down,
remove the SD card from the operating
module.
Fig. 1: Removing the SD card
2. Insert the SD card for activating the heat
meter again and turn on the power to the
system again.
If the card symbol appears in the upper right
corner of the TFT screen, the Smart Count
heat meter will be installed.
Overview
Next view Start animation
1
Fig. 2: Installing the heat meter
1: SD card symbol visible
3.
The activation process can be repeated
after a software update or re-commis-
sioning.
The installation of the software is finished
when the SD card symbol is no longer
visible.
Overview
Next view Start animation
1
Fig. 3: Installation of the heat meter completed
1: SD card symbol no longer visible
4. After the SD card symbol is no longer visible,
switch off the power to the heat pump again
and replace the SD card with the original
card that you had removed at the beginning.
Fig. 4: Replacing the SD card with the original card
5. After switching on the heat pump again, the
installation of the heat meter (Smart Count) is
complete.
NOTICE!
IMPORTANT!
A new activation card is required if the con-
troller is replaced!
7