REMKO Fin-tube heat exchanger - Manual (Page 9)

REMKO
FIN-TUBE HEAT EXCHANGER
9
6. Using the union nut 17, seal the insert
14 and insert the insulation clip 15.
7. Screw the insert 14 flat onto the
connecting fitting 6 until is rests against
the insulating plastic bushing 2.
8. Insert the insulating sleeves 4 into the
insert 14 and into the adapter nipple 18.
9. Establish the supply line to
the heating circuit and connect it to
the adapter nipple 18.
10. Screw the union nut 17 to the
adapter nipple 18; counter pressure
is provided by the the hex plate.
The max. torque is 15 Nm.
1 620 resistor
2 Insulating plastic
bushing
3 Cover plate
4 Insulating sleeve
5 Heat exchanger
6 Connecting fitting
7 Insulating sleeve
8 O-ring
9 Plastic angle
10 Swash plate
11 Brass strap
12 Hex nut
13 Flexible foam disc
14 Insert
15 Insulation clip
16 O-ring
17 Union nut
18 Adapter nipple
19 Flange plate