REMKO Fin-tube heat exchanger - Manual (Page 4)

4
REMKO
FIN-TUBE HEAT EXCHANGER
Carefully read the operating manual
before placing the unit in service for
the first time. It provides useful tips
and notes
! such as hazard warnings
to prevent injury and material damage.
Failure to follow the directions in this
manual can endanger persons, the
environment and the equipment itself
and will void any claims for liability.
■ Keep this manual in the vicinity of
the units.
■ Only qualified personnel may set up
and install the units and components.
■ Set-up, connection, and operation
of the units and their components
must be done in accordance with
the operating conditions as specified
in this manual and comply with all
applicable local regulations.
■ Modification of the units and
components supplied by REMKO
is not permitted and can cause
malfunctions.
■ Units and components may not be
operated in areas where there is an
increased risk of damage. Observe
the minimum clearances.
Safety notes
■ The operational safety of units and
components is only assured if they are
fully assembled and used as intended.
Safety devices may not be modified
or bypassed.
■ Do not operate units or components
if there are obvious defects or signs of
damage.
■ The units and components must
be kept at a safe distance from
flammable, explosive, combustible,
aggressive and dirty areas or
atmospheres.
■ Installation, repair and maintenance
work may only be carried out
by authorised specialists. Visual
inspections and cleaning can be
performed by the operator as long
the equipment is disconnected from
the power.
■ Take appropriate precautions when
performing installation, repair or
maintenance work or cleaning the
unit to make sure the unit does not
pose a danger to persons.