REMKO SLE 40 - Manual (Page 8)

Installation
For optimal and reliable unit op-
eration, the following information
must be observed in any event:
■ The unit must be mounted or
installed in a suitable location
appropriate to the structural
conditions.
■ The supplied wall bracket with
suitable fixing material (not
included) must be fixed securely
to the wall.
■ The unit must be mounted or
installed horizontally to ensure
free condensate drainage.
■ The unit must be mounted or
installed so that the air is able
to be sucked in and blown out
unhindered.
■ For optimal operation of the
unit, the minimum clearances
from the unit to the ceiling and
floor must be maintained.
■ The unit should not be installed
close to radiators or other heat
sources.
■ The room to be dehumidified
must be closed from the ambi-
ent atmosphere.
■ Open windows, doors, etc., as
well as frequent entering and
leaving the room should be
avoided as far as possible.
■ For optimal room air circulation
by the dehumidifier, the supply
and exhaust air openings must
always be kept free of dirt and
other obstacles.
Condensate drain
The condensate drain is located at
the bottom of the unit.
The condensate drain must be
connected to the supplied drain
connection.
A solid or flexible ½“ drain con-
nection can be connected.
■ The drain hose must always be
installed with a minimum gradi-
ent of 2% to enable the water
to drain unhindered from the
drip tray.
■ Alternatively, a condensate
pump (accessory) can also be
mounted on the unit in order to
pump the produced condensate
to an outlet.
■ For an outlet through the wall,
specific preparations are neces-
sary for correct condensate
drainage prior to installation
of the unit, e.g. the drilling of
holes.
■ The position of the outlet con-
nection is shown in the diagram
below.
Access to control
After removing 2 screws at the
top of the unit, lift up the front
panel and remove it from the unit
horizontally.
The control is located in a housing
above the compressor.
Access to the control takes place
by removing the 2 screws on the
front of the housing.
Wall mounting of units
Positioning the condensate drain
ATTENTION
The unit connections must al-
ways comply with the respec-
tively applicable installation
regulations.
318
105
ATTENTION
Careful and professional in-
stallation must be ensured.
8
REMKO SLE 40-80