REMKO AMT 40E - Manual (Page 13)

Cleaning the dust filter
Lightly push the guard grille
upwards, pull out and remove
downwards.
Remove the exposed dust filter.
If lightly soiled, the dust filter can
be cleaned by carefully blowing
out or by suction.
For heavy fouling, the filter can be
rinsed in a luke-warm (max. 40°C)
soap solution.
Subsequently rinse thoroughly
with clear water and allow to dry!
It must be ensured that the dust
filter is completely dry and undam-
aged prior to refitting.
The units must only be operated
with the dust filter fitted.
� Observe the regular care and
maintenance intervals.
■ Depending on the particular
operating conditions, the units
must be inspected annually
as required, however, at least
once by an expert for their safe
working condition
■ Keep the units free of dust and
other deposits
■ Clean the devices only with a
dry or moistened cloth
■ Do not use a direct water jet
such as a high-pressure clean-
er, and so on!
■ Do not use caustic cleaning
agents or cleaning agents con-
taining solvents
■ Only use suitable cleaning
agent, even in case of heavy
soiling
For convenient transport, the units
are provided with two large wheels
and an ergonomically shaped
transport and protective handle.
This can easily be removed if
required.
The following must be observed
for unit transport:
1. Prior to a change of location
switch off the unit and discon-
nect the mains plug from the
socket-outlet.
2. Empty the condensate
container.
3. As long as there is still moisture
on the evaporator or water in
the condensate container, the
units must only be transported
in an upright position.
Unit transport Maintenance and Care
All moving parts are provided with
low-maintenance permanent lubri-
cation. The refrigeration system is
a hermetically sealed system and
must only be repaired by author-
ised specialist companies.
CAUTION
The mains cable must never
be used for pulling or fixing
purposes.
NOTE
Regular care and maintenance
is a basic precondition for a
long useful life and trouble-
free operation of the unit.
CAUTION
Before carrying out all work on
the units, the mains plug must
be removed from the socket-
outlet.
NOTE
Heavily clogged dust filters
must be replaced with
new ones.
Only original spare parts
must be used.
NOTE
Attention must be paid to
dripping condensate.
After switching off the unit,
the evaporator can continue to
defrost under the influence of
the ambient temperature.
CAUTION
Regularly check air inlet and
air outlet as well as the dust
filter for fouling.
Regularly check air inlet and
air outlet for fouling.
CAUTION
13