REMKO PG 12E - Manual (Page 12)

12
– unit doesn’t start
– unit stops during operation
– fan blows, but gas supply is blocked
resp. no ignition
– flame goes out after having released the pin of
thermoelectric gas valve
– gas supply is blocked, resp. flame goes out
– fuel consumption is too high
– unit can’t be shut down
– heating capacity drops during continuous operation 1 – 2 – 3 – 4 – 7
2 – 4 – 7 – 12 – 13
4 – 5 – 8 – 9 – 12
8 – 10 – 11
4 – 6 – 7 –10 – 11 – 12 – 13
12 – 15
3 – 14
13
Troubleshooting
cause: trouble:
cause: remedy:
1. no electrical connection - plug the mains into an appropriate mains socket (230V/1~ 50Hz)
2.
fan motor is overcharged
(fan blows irregularly or is blocked) - check fan motor, fan blade and clutch plate and replace if neces-
sary.
3. operating switch defect
- close gas supply, unplug the mains and replace defect operating
switch
4. no gas pressure on solenoid valve
- check gas supply
- check contents of gas bottle(s)
- check gas hose(s) for damage
- release hose-break protection resp. replace it
5. no ignition spark
- set ignition electrode
- check ignition cable
- check porcelain insulation of ignition electrode
6. air-suction grille dirty - clean air-suction grille
7. unit is shut down by temperature limiter
- check air-suction and blow-out grille and clean if necessary
- check fresh air supply
8. safety pilot does not open (resp. does not lock) - replace safety pilot
9. piezo electric igniter defect - replace piezo electric igniter
10. thermocouple resp. temperature limiter defect - check position of thermocouple and adjust according to setting hints
11. loose or dirty connection between safety pilot and thermocouple - check connection and clean if necessary
12.
pressure controller defect or false pressure controller mounted
resp. hose break protection is blocked - mount original pressure controller
- release hose-break protection resp. replace it
13
gas bottle(s) iced over due to low temperatures and too high gas
taking - replace empty gas bottle(s) and connect 2-3 bottles using multi bot-
tle set (EDV-No. 1014050)
14. solenoid valve does not open
- close gas supply
- let flame burn out
- put operating switch in position „0” and unplug the mains
- replace solenoid valve
15. leak gas hose(s) - find leakage by foam forming mediums eliminate leakage
Make sure that the gas supply has been closed and the mains plug has been taken out of the mains
socket before carrying out any work regarding the unit!
Setting and maintenance is to be carried out by authorised experts only!