REMKO ETF 220 - Manual (Page 7)

7
Depending on the air temperature and the relative hu-
midity, the condensed water drips out steadily or only
during periodic defrosting phases into the collection
tray and then into the condensation collector beneath
it through the integrated drainage lines.
A float regulator flap is installed in the condensation col-
lector that interrupts dehumidification operation via a mi-
croswitch when the collector is full.
The unit switches off and the LCD display "Collector full“
lights up. It goes off again when the condensation col-
lector is emptied and replaced. The unit then restarts af-
ter a delay of approximately 2 minutes.
For unsupervised, continuous operation of the unit, the
condensation is continuously drained via an external
water hose.
Display
The unit has an LCD display which shows the relative
humidity of the room, the operating mode and other im-
portant information.
6
1 2 3 4 5
7 8
1 "Fan speed" display
2 "Dehumidification" display
3 "Collector full" display
4 "Defrost mode" display
5 "Operating mode" display
AUTOMATIC 45% - 55% rel. humidity
COMFORT 55% - 65% rel. humidity
MAXIMUM
VENTILATION
6 "Timer" display
7 "Elapsed time" display
8 "Relative humidity" display measured on the unit
sensor.
Setup
Follow the instructions below to ensure the to optimum,
economical and safe operation of your unit.
◊
The unit must be securely placed in an upright posi-
tion so that condensation can drain freely into the
condensation collector.
◊
If possible, place the unit in the middle of the room to
ensure optimum air circulation.
◊
Maintain a minimum distance of 50 cm to walls.
Fenster
geschlossen
halten
Tür
geschlossen
halten
Wan
dabs
tand
min
d. 0,5
m
Ab
sta
nd
zu
H
eiz
kö
rpe
rn
od
er
an
de
ren
W
ärm
eq
ue
lle
n h
alt
en
◊
Make sure that the air can flow freely into the back of
the unit and out of the upper air flap.
◊
Do not place the unit in the direct vicinity of radiators
or other heat sources.
◊
Keep the room to be dried or dehumidified closed so
that air from the surroundings cannot get in.
◊
Keep windows and doors closed and avoid entering
and leaving the room frequently.
◊
If the unit is in operation in a dusty environment, the
appropriate service and maintenance measures are
to be undertaken in accordance with the specific
conditions.
See chapter "Maintenance and Service".
◊
You can improve the air circulation if you set up the
unit at a height of approximately 1 m.
Important information about the electrical connec-
tion
◊
The electrical connection of the unit is to be carried
out in accordance with DIN VDE 0100, Part 704 to
electrical supply points with residual current circuit
breakers.
◊
When the unit is set up in wet areas such as in bath-
rooms
or kitchens, the unit must be equipped by the
customer with a residual current circuit breaker that
meets regulations.