REMKO ETF 400 - Manual (Page 9)

Electrical connection
■ The units are
operated
with 230 V / 50 Hz
alternating current.
■ The electrical connection
is made using a built-in mains
cable with earthed safety plug
■ Extensions to the connection
cable may only be carried out
by authorised electricians,
subject to the length
of the cable, connected load
of the unit and taking into
consideration how the unit
is used at its location
Set-up
For the best economic and safe use
of the units, the following notes
must be followed in full:
■ The units must be set
up in an upright and level
position, so as to ensure
unobstructed flow
of the condensate
■ To ensure optimum air
circulation, the units should
be set up in the centre
of the room, where possible
■ It must be ensured that the air
can be sucked in on the front
of the unit and blown out
of the rear of the unit without
obstruction
■ Observe a minimum clearance
of 50cm from walls at all times
■ Units must never be set
up in the immediate vicinity
of heaters or other sources
of heat
■ Air circulation is improved
if the unit is set up approx. 1 m
above the ground
■ The room being dried
or dehumidified must be closed
to the neighbouring atmosphere
■ Avoid having opened windows
and doors etc., and avoid
frequent entry to or exit from
the room as much as possible
■ If the units are to be used
in dusty environments
or stables, appropriate care
and maintenance measures
should be taken according
to therelevant conditions
■ The output of the unit is entirely
dependent on the conditions
inside the room, room
temperature, relative humidity
and observance of the set-up
instructions
NOTE
The electrical connection
to the units must be made
at feedpoints with residual
current devices in accordance
with VDE 0100, Section 704.
When installing the units
in extremely damp
environments such as laundry
rooms, showers etc.,
the customer must ensure
that the unit is secured
with a residual current
device in accordance with
the regulations.
Wall clearance
min. 0.5 m
Maintain adequate clearance from
heaters or other sources of heat.
Keep windows and doors closed!
ATTENTION
All cable extensions must
only be used in a rolled out
or unrolled state.
!
9