REMKO ATR-4 - Manual (Page 8)

8
Setting the Functions
When you press the PROG program button for 6
seconds, you are taken to a menu where various
basic functions can be set. The functions are
shown on the left-hand side of the display and
the corresponding value or status on the right.
When you press the SET program button, you are taken to the desired set-
ting option. The setting option blinks on the display.
By pressing the + or – program buttons, the value of the selected setting op-
tions can be changed and your selection confirmed by pressing the SET
button.
After confirming the last function, the unit returns to the operating mode from
which the
“Setting the Functions” menu was accessed.
The individual parameters mean the following:
Setting the Control Parameters
When you press the PROG program button for 6
seconds, you are taken to a menu where various
basic functions can be set. The functions are
shown on the left-hand side of the display and
the corresponding value or status on the right.
When you press the SET program button, you are taken to the desired set-
ting option. The setting option blinks on the display.
By pressing the + or – program buttons, the value of the selected setting op-
tions can be changed and your selection confirmed by pressing the SET
button.
After confirming the last function, the unit returns to the operating mode from
which the
“Setting the Control Parameters” menu was accessed.
The individual parameters mean the following:
When used as a two-point control mechanism:
Parameter Default setting Minimum value Maximum value
Activation difference ± 1.0 K ± 0.1 K ± 3.0 K
Per proportional control ± 3.0K ± 1.0 K ± 10.0 K
Pulse width 5 min 1 min 15 min
When used as a pulsating control mechanism: