REMKO ELT 9-6 - Manual (Page 4)

4
REMKO ELT 9-6
Safety information
Operation of the heaters must always take place in compliance with
the local building and fire protection regulations and regulations of the
employers‘ liability insurance associations.
The units were subjected to
extensive material, functional and
quality inspections and tests prior
to delivery. However, the units
may constitute a hazard if used by
untrained personnel, improperly or
not for the intended purpose.
The following information must be
observed
■ Before starting work, persons
responsible for the operation of
the units must check for obvious
defects on control and safety
devices and for the presence
and correct functioning of
protective devices.
Any noticed defects must be
reported to the responsible
supervisor!
■ Units that have defects liable
to affect their reliability must
immediately be switched off.
■ For using the units, the
respective local regulations and
electrical fuse protection ratings
must be observed.
■ Safety distances to flammable
objects must be observed.
■ The air inlet and air outlet vents
must be kept free at all times.
■ The air outlet vents must not
be restricted or pipes or hoses
connected.
■ Never insert foreign objects into
the units.
■ The units must not be covered
whilst in operation.
■ Safety devices must not be
overridden or blocked.
■ The units must not be used near
to baths, showers, swimming
pools, etc.
■ The units must not be used
directly below a wall socket-
outlet.
■ The units must not be exposed
to direct water jets.
e.g. high pressure cleaners, etc.
■ Never allow water to enter the
unit.
■ The units must not be installed
and used in locations subject to
fire and explosion hazards.
■ The units must not be installed
and used in oil, sulphur, or salt-
laden atmospheres.
■ All electrical cables of the units
must be protected against
damage, also damage caused by
animals.
Unit description
The units are portable electric
heaters for commercial use.
The units are designed solely
for electrical use and for fully
automatic, universal and problem-
free operation.
The units have special
encapsulated electric heating
resistors, a low noise and
maintenance axial flow fan, a
safety and cooling thermostat, an
integrated room thermostat and
power cable with earthing pin
plug.
The units comply with the
fundamental safety and health
requirements of the pertinent EU
directives.
The units are reliable and easy to
operate.
The units also have the following
applications:
■ Drying new buildings.
■ Concentrated heating of
outdoor workplaces or for use
in halls and manufacturing
facilities not subject to fire
hazards.
■ Continuous or temporary room
heating.
■ De-icing of machines, vehicles
and non-flammable stored
goods, maintaining the
appropriate safety distances.
ATTENTION
Safety devices must not be
overridden or blocked.