REMKO RVS xxx H - Manual (Page 12)

Fault reset
To protect the system from damage, the controller checks the tempera-
ture, pressure, configuration, etc. of the relevant safety components by
means of sensors and inputs. The controller’s display shows a series of
letters as a coded fault report. A fault code given corresponds with a
cause (see table “Coded fault reports”).
The controller shows the current faults one after the other.
Simultaneously pressing key-pad and can, after the fault has been
corrected, be used to confirm the correction.
Faults are saved in a fault list. A password must be used to delete the list.
Call up of fault reports
(See chapter on trouble-shooting and customer service)
Differential pressure monitor
Fault deleted
High pressure
High pressure
min. 5 sec.
min. 5 sec.
+
+
automatic
2 sec.
automatic
2 sec.
automatic
2 sec.
short-term short-term min. 5 sec.
+
REMKO RVS...H (INOX)
12