REMKO RKS 327 H - Manual (Page 9)

9
COOL mode Use the “COOL” mode when you want to cool down the room to the desired tempera-
ture.
Decrease the temperature by pressing the button in 1°C Sc increments. The indoor
unit’s receiver indicates that the settings are being correctly received by beeping. After
approximately 3 minutes, the air-conditioner starts working. This delay is for safety pur-
poses for the compressor to prevent a “cycle” (compressor switches on and off). If the
room temperature falls approx. 2 C° below the set temperature, the unit automatically
stops cooling.
Functional process
COOL AUTO COOLING MODE
DRY mode
Due to the low temperature of the refrigerant, the cooling register falls below the dew
point of the air which causes the moisture in the air to condense. The “DRY” mode de-
humidifies the room. After the “DRY” button has been pressed, the desired temperature
and the plate fin position can be set. The fan switches off at certain intervals to lower
the temperature of the plate fins.
DEHUMIDIFYING MODE
Functional process
DRY COOL
Fan button When the FAN button is pressed, the fan speed display “AUTO” becomes visible. The
speed is lowered each time the button is pressed.
Functional process
AUTO LOW MED HIGH
HEAT mode
In the “HEAT” mode, you can heat the room during spring and fall. Press the “HEAT”
button. Keep in mind that the temperature you set must be higher than the room tem-
perature! If the set room temperature is exceeded by 1 C°, the unit switches the heating
off automatically. If the room temperature is below the set temperature, the heating
switches on again after 3 minutes.
Functional process
HEAT DRY HEATING MODE
AIR
DIRECTION button The button cannot be activated for these units.
FAN mode
Functional process
FAN HEAT FAN MODE
To activate circulation mode, press the button once or several times until “FAN”
appears on the display. In this mode, the unit is used for circulation. It does not cool or
heat.