Demco 9518171 - Manual (Page 4)

NOTE: Use Blue on threads and tighten
bolts according to bolt chart on front page.
11. Reinstall bumper and grill.
9. If drilling is needed insert shorter bolt using needle
nose pliers as shown above.
8. If no drilling is needed proceed to step 10, On
models where drilling is needed, drill 1/2” holes
on inside of frame using holes as template. Slide
baseplate between frame horns(If there is a gap
between frame horns and baseplate insert shim as
shown on front page). Use the shorter metric bolts
shown on front page (12mm-1.75 x 40mm Gr. 8.8).
Top bolt on each side will go inward and bottom bolt
will go outward as shown on front page.
NOTE: Use Blue on threads and tighten
bolts according to bolt chart on front page.
10. Use longer bolts (12mm-1.75 x 100mm Gr. 8.8) if
no drilling is needed, slide baseplate between frame
horns(If there is a gap between frame horns and
baseplate insert shim as shown on front page), top
bolt on each side will go inward and bottom bolt will
go outward.