PSE Archery Vector Crossbow 2015 - Manual (Page 4)

CROSSBOW OWNER’S GUIDE
®
4
VECTOR CROSSBOW COMPONENTS
Before assembling your crossbow please check to see if all crossbow parts are included:
1- Prod, 1- Stock, 3 - Crossbow Bolts, and 1 - Cocking rope, 1 - Prod Bolt, 1 - Washer
(not shown), 2 - Allen Wrenches, 1 - Rail Lube (not shown), 1 - Quiver Mount, 1 - Mouting
Bracket Extension, 1 - Foot Stirrup, and 1-Quiver. (Fig. 1 & 2). If any of these parts are
missing please contact PSE Customer Service.
Insert shoulder sling receiver bolt into hole on side of barrel just behind where the barrel and
prod assembly connect. Fig. 3
Connect the barrel and the prod assembly by inserting the cable slide and cables into the
slot on the barrel as shown in Fig. 4a. Be sure the concave side is facing up to match with
the contour on the inside of the barrel.
Push the cables into the track and position the prod for connection to the barrel using the
prod bolt, washer and hex key provided. Tighten the center set screw to lock the barrel
connector, in order to hold the riser in the correct position. Fig 4b.
Insert the foot stirrup into the two holes on the front of the prod. Fig 5a. Make sure the two
notches in the foot stirrup are facing towards the set screws used to secure the stirrup. Use
the hex key to tighten the stirrup screws as shown in Fig. 6.
Comfort Molded Grip
Full-length barrel foregrip
Large Boot Style Foot
Stirrup
Lightweight Integrated
Composite Stock/Barrel
4x32 Multi-Range Scope
Precision Trigger / Auto Safety
Fig. 1
Cam
Limbs
Quiver
Prod Assembly