Profax AEC 200-1 - Manual (Page 2)

F1
11
5
V
A
C
24
V GRD
BLACK
CR1
8
9
9
6
3
5
CR1
B CR
1
SR
1
CR1
AC
R1
TRIGGER
(JOG optional)
M
CR1
A
4
7
TS1
1
2
3
4
TS2
22
21
20
16
15
14
13
23
SPOOL GUN
AC
115 VOLT AC
POWER CABLE MODEL
AEC 200-1
CONTROL
115 VOLT AC
*PLUG NOT INCLUDED
MULTI CONDUCTOR
CABLE TO TERMINAL
STRIP IN CONTROL BOX
MODEL
AEC 200
SPOOL GUN
WORK
WELDING CABLE FROM
NEGATIVE OUTPUT TERMINAL
ON POWER SOURCE
GAS & WELDING
CABLE
GAS
CYLINDER
HOSE TO GAS
SUPPLY
CONNECTION
BLOCK
CABLE
BOOT
WELDING CABLE TO
“GUN” STUD ASSEMBLY
ON CONTROL BOX
POWER
SOURCE
CONTACTOR CONTROL
CABLE TO CONTACTOR
CONTROL RECEPTACLE
ON POWER SOURCE
(see installation instructions)
POSITIVE
OUTPUT
TERMINAL
CONSTANT VOLTAGE WELDING POWER SOURCE WITH AEC 200-1 CONTROL
LIMITED WARRANTY - Subject to the terms and conditions hereof, PROFAX, Pearland, Texas warrants its control boxes to be
free from defect in workmanship and material at the time of delivery by PROFAX.
PROFAX will honor warranty claims on this equipment as a result of failure from a defect for a period of one year from date of
sale to the original user.
Upon the return of this unit at users expense, PROFAX reserves the right to either repair or replace as necessary.
This is the only warranty either expressed or implied covering this unit.
To install:
1. Remove top cover from control unit.
2. Install the multi-conductor cord from the AEC 200 Welding Gun through the access hole in
the front panel of the control box and connect the numbered wires to the corresponding
numbers on the 8 pole terminal strip TS1.
3. Connect the contactor control cord on the back of the control box to the contactor control
receptacle on the welding power source.(See Note)
4. Connect the 115 volt A.C. power cord from the control box to a 115 volt A.C. power source.
5. Replace top cover and tighten screws.
CAUTION
Disconnect all electrical power to
the welding power source before
installing this control unit.
AEC 200-1
Warranty
AEC 200-1 AEC 200-1
Warranty Warranty
NOTE
Terminals 1 and 2 on the four pole terminal strip TS2 are for use with welding power sources requiring a normally open
set of contacts for power source contactor operation. This set of contacts will close when the gun switch is operated.
Terminals 3 and 4 on the four pole terminal strip are for use with welding power sources requiring 115 VAC to be supplied
to the power source for contactor operation.
This control box comes with the contactor control cord connected to terminals 1 and 2.
WHITE