Profax TC-2B - Manual

January 2007
®
® OWNER’S MANUAL ESAB TC-2B
REMOTE FINGER TIP CONTROL
•Do not touch live electrical parts.
•Shut down and disconnect power to welding power source before making control connections.
•Be sure control is turned off before turning the welding power source on.
See reverse side for further safety information.
WARNING Electric Shock can kill.
INSTALLATION
1. Position finger tip control onto tig torch
2. Secure control to torch with supplied TY-Wraps
3. Connect plug to power source by aligning keyway,
inserting plug and tightening threaded collar.
4. Be sure that the control is in the off position
before turning power source on.
NOTE: On water cooled tig torches be sure to loosely secure hoses and cables in as few places as possible. This will prevent heat transfer
between water lines. If using a torch cable boot, leave hoses and cables loose inside boot.
PROFAX is in no way affiliated with ESAB . The parts adver tised for sale are not genuine parts, but are par ts made for and by PROFAX. References to machines, torches, and numbers
are for your convenience only. We reserve the right to substitute genuine parts in place of PROFAX parts.
® ® ® ESAB ESAB
® ESAB
00340OG070210
R
1
B
A
F
E
D
ON
OFF
CW
Shield Cable
Clamp
White
Black
Brown
Green
Red
Jumper
Wiring Diagram
TC-2B
ITEM NO. PART NO. DESCRIPTION TC-2B
1 PXS12020-32 Plug, 14 pin 1
2 PX9672 On/Off label yellow 1
Parts
OFF
1
2
® The “PROFAX” TC-2B remote fingertip control can only be used with the following ESAB welding power sources.
• Miniarc 90i • Miniarc 140i • Heliarc160i
• Heliarc 161 AC/DC • Heliarc 252 AC/DC • Heliarc 352 AC/DC
G
H