Directed Electronics OHD1040 - Manual (Page 12)

© 2004 Directed Electronics, Inc.
B BA AT TT TE ER RY Y R RE EP PL LA AC CE EM ME EN NT T
NOTE: Before using remote after installation, remove the battery plastic protective
slip.
1. Move the small latch to the right and slide out the battery holder.
2. Remove old battery and replace it with a new battery (CR2025) with the positive “+” sign facing
as shown above.
3. Push battery holder back into its compartment until it is locked.
P PR RE EC CA AU UT TIIO ON NS S
1. Properly dispose of used battery.
2. Do not misuse battery by shorting the positive “+” and negative “-” terminal or put it into fire.
Overheating may cause the battery to explode and cause a fire hazard.
3. If the remote is not to be used for a long period, remove the battery from the remote to prevent
damage from battery leakage.
4. To avoid accidents, prevent children from playing with the battery.
Remote Controller
Battery
Battery Holder Latch
+ side
12