Posiflex CD-3860 User Manual
Page 22
22
End Of Configuration
Start Of Configuration
3.
Want Emulation Setting
Wand emulation is a standard interface but requires special firmware. If needed,
please contact your distributor.
Barcode
Value
Barcode Label
Description
WD01
All barcode will be decoded and transmitted in that
symbology
WD02
Enable Wand output data format as Code 39
WO01
Wand emulation data output black = high
Scan this barcode to set quiet zones and spaces
low and bars =high.
WO02
Wand emulation data output black=low
Scan this barcode to set quiet zones and spaces
high and bars=low
WO03
Idle = high
Idle state refers to the TTL logic level of the
Wand Emulation signal when not in use
WO04
Idle = low
Idle state refers to the TTL logic level of the
Wand Emulation signal when not in use
WS01
Wand emulation speed---Low
This option allows the transmission of wand
emulation at 1ms narrow element width
WS02
Wand emulation speed---medium
This option allows the transmission of wand
emulation at 600us narrow element width