Posiflex CR-2000 Series - Manual (Page 4)

Part 4
CR-2000:
1). Connect the 8 pin plug of CR cable to cash drawer and the 6 pin plug to
CR port of POS system or POS printer as shown below:
2). Turn the keylock to standby position.
CR-2004:
1). Connect the 4 pin RJ11 plug of RS232 conversion cable to the RJ 11
jack at the rear side of CR-2004 and connect the DB 9 pin connector
to RS232 port of host (PC or POS) system as shown in drawing below.
2). Check the specification of power adaptor on its nameplate. Insert the
power adaptor into the correct power outlet. Insert the output plug to
the power jack at rear side of CR-2004 to supply power for drawer
kickout.
3). Turn the keylock to standby position.
4). Set the communication protocol of the RS232 port in host system to
use baud rate of either 9600 bps or 19200 bps.
Cash Drawer With RS232 & USB Interface
Connect to RS232 port of host system
(For CR-2004 only)
RJ11(4P4C) Telephone Jack
Rear View
Connect to USB Port of host
system (For CR-2005 only)
Connect to Adaptor
USB Type B Connector AC 12V I/P
RS232 Conversion Cable:
(21863159900/21863259900) USB Cable:
(21863150800/21863250800)
Cash Drawer
With Printer Interface
Connect to POS System or
Printer 6P Telephone Jack
8P Telephone Jack
Output to drawer
Rear View
CR Cable: 21863018010